HT30A BNC to Dual Banana Head Test Line Auto Test Leads +Breakout Leads(HT301)

Description

Package contents: 1pc* Ht30a Auto Lead 1PC*Breakout Leads(HT301)
Package contents:
1pc *Breakout Leads(HT301)
1pc* Ht30a Auto Lead
Auto Test Leads (Ht30a)
Test Lead of a Male Bnc Connector to (2) 4mm Connectors. It's a Special Line for Assisting Automobile Measurement Instruments to Test Various Types of Signals. 4mm Connectors Are Coded in Two Colors, Black and Red. Lead Length 30 Meter.
The Auto Test Cable (Ht30a) Is a Kind of Special Line for Assisting Automobile Measurement Instruments to Test Various Types of Signals.
It's About 3 Meter in Length Allows the Oscilloscope to Be Placed on the Work Bench Away from the Car Being Tested or Repaired.
It Consists of Wide Range Probes, Clips, Gators Can Be Plugged into the 4 Mm Connectors at the End of the Cable.
It Adopts Full Shield Which Can Help Reduce the Noise Interference.
To Avoide the Lines Twisting Together, the Two Pieces of Lines with Connectors Are Not the Same in Length.
The Short Line Is Earth Wire, and the Long Line Is Positive Pole Which Should Be Connected with the Auto Engine Cable, Which Also Can Cooperate with a 20:1 Attenuator.
Breakout Leads(HT301)
This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment. Connect the breakout lead plugs into the existing wire loom, and insert the two 4mm banana plugs into the oscilloscope using test lead HT30A, the output signal can be taken.
Following sensors can be connected:
Multi-point injection nozzle
Single-point injection nozzle
Induction crankshaft sensor or camshaft sensor
The temperature sensor
Knock sensor
GM ignition coil
Lk hua ignition module
Bosch mechanical injection system - warm-up regulator, subsidiary air valve, temperature timer switch, cold start nozzles.
Lead Length:
Red: 300mm
Yellow: 900mm